- Blank 2 ply truss rod cover - fits many Epiphone Les Paul guitars and others
- Aftermarket - not a Genuine Epiphone® truss rod cover
- The shape is a modified version of the Epiphone® truss rod cover.
- **Please check the above measurements before ordering**
- 2 ply black/white (1.5mm thick)
- Mounting screws are not included
- Qty 1
MM or CM to Fractions of Inches
-
Poor-quality piece.
Other products from Philadelphia Luthiers have been great for me, but this is not usable. It's clearly supposed to be the same screw pattern as my stock one, but one of the lower holes is off by a couple of millimeters. The screw holes aren't symmetrically lined up with the shape of the plastic piece. The bottom edge lacks the reverse bevel that would let it sit flush against the slope of the nut like the stock cover does. And finally, it's just really cheap plastic. The black finish is dull, not glossy like the piece it's supposed to replace, and scuffs extremely easily. Mine already looked ugly and beat up when I took it out of the package. I'd rather have no truss rod cover at all than try to use this. -Admin - Hi Tom, as far as the product finish, you need to remove the protective film from the truss rod cover - It will be glossy once it is removed. For the fit, they original varied a lot, that is the reason we asked you please check the dimensions carefully before ordering. They might look similar but I've seen them vary a lot over the years of production.
-
Perfect fit
I dislike truss rod covers with writing on them, so this was a perfect solution and a perfect fit for my Epiphone Les Paul. Sure, the shape is a little different, but I think it actually looks better than the original, and I love that it's blank.
-
Awesome
Perdect fit for my Les Paul