- Metric Locking Tailpiece Studs
- Made in the USA
- Steel body and cap
- 1/8” Allen wrench (not included) to adjust post height
- Mounting studs with metric threaded M8 x 1.25 threads
- 7/8" (22.4mm) thread length
- Fits tailpiece with a minimum ears thickness of .250" (6.4mm)
- Set of 2
Instructions:
To lock the tailpiece to the studs simply tighten the slotted cap. To adjust the tailpiece height, first, loosen the slotted cap slightly and insert a 1/8” Allen wrench (not included) through the top. Retighten the slotted cap once you reach the desired tailpiece height.
MM or CM to Fractions of Inches
-
Locking tailpiece studs
Great quality, fast dispatch, am now using these on all my wraparounds.
-
Thread portion larger than PRS SE studs
I bought a pair of these attempting to fix the angled (wraparound) tailpiece issue on my PRS SE custom semihollow... the thread fits fine but the threaded portion of this studs is about 3/8" larger than the original therefore it will not allow setting the bridge for low action. Anyway I will look forward for a future version with shorter threaded portion. :( The quality is very good, I rated 3 stars based on my Customer Support inquiry before I bought these.
-
lock down wrap around
Used these to lock a warp around bridge that seemed to lift at the rear. Worked perfectly. Chrome was finished great;lock keeps the bridge tight. Highly recommended!
-
Great locking studs!!!!
Great hardware, very good quality and fit. I have already purchased 3 sets. In my opinion it's a must have, first thing I do to my new guitars!!!