- Replacement Mounting Ring Screws for Gibson Les Paul
- Steel
- Available in Nickel and Gold plated
- Qty 8 (4-long, 4-short)
Bridge Mounting Ring Screws
- (A) Overall length approx. - 3/4" (20mm)
- (B) Shank diameter approx. - .100" (2.5mm)
- (C) Head diameter approx. - .195" (5mm)
Neck Position Mounting Ring Screws
- (A) Overall length approx. - 3/8" (10mm)
- (B) Shank diameter approx. - .100" (2.5mm)
- (C) Head diameter approx. - .195" (5mmm)
These are the correct size screws for replacing old and tired-looking mounting rings screws on a Gibson Les Paul. Might differ slightly in appearance from the original screws but are the same size.
These will not fit vintage Gibson Les Paul or reissue models. Please measure before placing your order to make sure this screw will fit your application.
**slight variation from listed screw dimensions is normal.
MM or CM to Fractions of Inches
-
Les Paul Humbucker Mounting Ring Replacement Screws
I decided to put Gold Hardware on my Les Paul and these were perfect for the Mounting Rings.
-
Stripped
Every screw stripped and broke off. Terrible waste of money. Would request a refund if possible. Admin - if the stripped or broke the screws it is because either didn't predrill or made the incorrect size pilot hole. All screws should be used in predrill holes are you will damage them.
