- Copper Foil Tape for Control Cavity Cover Shielding
- Conductive Adhesive
- Peel off backing for easy installation
- Actual Dimensions - 11 13/16" (300mm) x 9 13/16" (250mm)
- Thickness - .002" (.06mm)
- Large enough to shield an entire Strat-style pickguard with one-sheet
- Easy to cut with scissors or utility knife
- 5 sheets - Shipped flat
Shielding the control cavity will help reduce hum, noise, and radio interference. No solder required when overlapping pieces because of the conductive adhesive. Peel off backing makes for a clean and easy installation.
MM or CM to Fractions of Inches
-
Nice Product
I used to work for a sign company and I'm comfortable working with thin adhesive-backed products on complex surfaces. Knowing how to avoid/remove/deflate air bubbles and chase wrinkles is helpful when using these sheets. This stuff is easy to work with and seems like a high quality product. I shielded a Strat-style pickguard and prefinished body with it. I went slow and ended up with a very nice result, with perfect continuity throughout. I made paper templates for the cavities and cut the copper accordingly. The few wrinkles that showed up were fairly easy to chase out. Bottom line - I'm very happy with my purchase. I think it's a good price too, especially for small runs or one-off projects.
-
Just what the doctor ordered!
As advertised, great quality, easy to use and reasonably priced. Not only pickguard application but also lining the electronics cavity under the pickguard. Highly recommended.
-
Copper Shielding
This is the only copper shielding I use and have been using for a while. It does dull up with time, as expected
-
Good quality
Very good quality sheets for Pickguard use.