Nashville to ABR-1 Conversion Posts - Nickel

Conversion posts - US Nashville to ABR-1 M5 to .140" - Nickel

1 review Write a Review
$9.95
SKU:
BP-1245-NK
  • Conversion Posts post/thumbwheel assembly
  • Made in the USA
  • Nickel plated steel posts and anchors
  • thumbwheel and posts are a single assembly
  • M5 x .8 to smooth .140" (3.6mm) diameter posts**
  • Qty 2

These conversion posts will allow you to install a US ABR-1 bridge on a Gibson guitar that was originally equipped with a Nashville bridge. Now you can have the same look as the original vintage Gibson guitars! These posts will screw directly into the original body anchors and leave you a non-threaded post to install a US ABR-1 bridge. The single assembly post/thumbwheel is a better design than the original ABR-1 posts. Less wobble, no protruding posts and less complicated. Check out our store for a selection of US ABR-1 bridges that will fit these conversion posts.

**These will only fit Gibson USA guitars and not the fake Gibson guitars from China!

1 Review Hide Reviews Show Reviews

  • 5
    Conversion posts - US Nashville to ABR-1 M5 to .140" - Nickel

    Posted by Fred Bergen on Jul 23, 2018

    If you want a 5 minute way to prove how much more musical ABR-1 bridges are (even if imperfect), try these out. There's sort of no going back once you have these.

    I put the Faber BSWKIT on a couple of SGs years back, and while they looked good and worked fine, the steel posts took away too much SG warmth. Not these.