- Thin wall box end truss rod wrench
- For adjusting 1/4" brass truss rod hex nut
- Deep socket head 1 3/16" (30mm)
- Chrome plated
- Allparts # LT 4215-000
**These have a deep socket head that might not fit your guitar. The socket head is 1 3/16" (30mm) long. Please check before ordering.**
MM or CM to Fractions of Inches
-
truss rod wrench was PERFECT
This wrench was exactly right for the Baby Taylor truss rod nut I needed to adjust. Definitely needs to be correct and it was...had already wasted money on another order that was metric equivalent, that one did NOT fit. These guys got it right...
-
Gets the job done!
Nice, simple tool that fit perfect for my old Taylor Big Baby. I was slightly worried because that model is said to have had truss rod access through the soundhole pre-2012, and mine was at the headstock even though it's from 2006, so I didn't know for sure if this would be the right size, but it was. And now it plays even better than it did before.
-
1/4 truss rod wrench
Work perfectly as it should
