- Brass ABR-1 thumbwheels with fine knurling
- Made in the USA
- Set of 2
- Nickel finish
- Fits USA Gibson® guitars equipped with ABR-1 bridge
- SAE 6-32 threads
- .109" (2.8 mm) thick and .63" (16 mm) diameter
3 Reviews Hide Reviews Show Reviews
I thought these were the thin ones like the original were, however I bought several pairs and only 2 sets were the thin ones. The rest were considerably thicker. Not the spec I ordered.
I cannot see the difference between these and any of the fine knurled thumb wheels on my Vintage Gibson's with ABR's (7 from 1952 - 1965). Well except for the wear. I add these under the originals to make the posts look correct to me as well as I hear a slight increase in sustain. If it is too think I file it thinner until I get a dead on tight to the guitar post fit. It makes a noticeable difference.
Definitly shopping here again..these guys are the bomb and excellent service via prompt email response etc and postage and handling to me in New Zealand. Rate these guys! ;o)